2 Pack Addicore nRF24L01+PA+LNA with Antenna in Antistatic Foam Arduino Compatible
2 Pack Addicore nRF24L01+PA+LNA with Antenna in Antistatic Foam Arduino Compatible
30 Days Lowest Price Guarantee

2 Pack Addicore nRF24L01+PA+LNA with Antenna in Antistatic Foam Arduino Compatible

$ 9.95

DESCRIPTION

Product Contents:
• 2 pieces nRF24L01+ module with PA and LNA in anti-static foam
• 2 pieces 2.4GHz 2.2dBi Duck Antenna
• 2 pieces anti-static bag
• 1 piece Addicore NRF24L01+PA+LNA information card with header and castellation pinout diagram

Specifications:
• The nRF24L01+ is a 2.4GHz ISM band transceiver
• Range: 800+ meters line of sight
• Includes on board support components and the RFX2401C which is the PA (Power Amplifier) and LNA (Low-Noise Amplifier)
• A host microcontroller can communicate and configure the nRF24L01+ over a 4-pin Serial Peripheral Interface (SPI). The configuration registers are accessible through the SPI connection. Configurable parameters include frequency channel (125 selectable channels), output power, and data rate (data rates: 250kbps, 1Mbps, and 2Mbps).
• The on chip voltage regulator accepts supply voltages from 1.9 to 3.6V.
• The module has 5V tolerant inputs which allows for direct connection of SPI pins to the Arduino.
• Internal filtering results in high margins of meeting RF regulatory standards. The module's radio uses Gaussian Frequency-Shift Keying (GFSK) modulation as well as fast Automatic Gain Control (AGC).
• The module includes an Interrupt Request (IRQ) pin which can be used to wake the host microcontroller, (ex: Arduino), from sleep when the module receives a transmission providing great power conservation in battery devices.
• Auto-acknowledge and auto-retransmit abilities
• Weight: 13.28 g (0.468 oz)
• Board dimensions, excluding pins: 15.5mm (0.61") width x 40.7mm (1.6") length x 12.2mm (0.48") height
• Dimensions of antenna, when angled at 90 degrees: 87mm (3.43") height x 9.5mm (0.37") diameter
  • Pins are protected in anti-static foam and modules are in antistatic bag with Addicore NRF24L01+PA+LNA information card
  • Arduino and Raspberry Pi compatible wireless 2.4GHz transceiver
  • Includes 2.4GHz 2.2dBi duck antenna
  • Signal PA (Power Amplifier) and LNA (Low-Noise Amplifier) extends the range of this module considerably
  • Applications: wireless peripherals, remote control systems such as RC vehicles and consumer remote electronics, wireless voice transmission such as VoIP, wireless sensor networks, wireless networks, home and commercial automation
Pins are protected in anti-static foam and modules are in antistatic bag with Addicore NRF24L01+PA+LNA information cardAddicore

YOU MIGHT ALSO LIKE