D4 AWD 1:10 is 3Racing for the drift car further development results; the motors can be set in the car's rear, further to move the center of gravity, coupled with the increase of the steering angle, allowing the rider to can create a greater angle of drift.
Full car FRP (glass fiber) (floor, two floor, front and rear oil pressure plate)
The floor of the whole vehicle, the two floor, the front and rear hydraulic panels are made of glass fiber materials, so that the body is more lightweight but also enhance the durability of the car.
Adjustable upper Y forearm
Can be adjusted on the forearm Y, so that drivers can be adjusted according to the needs of different venues angle angle, thereby enhancing the stability of the vehicle at high speed, the steering response and flexibility.
15 degrees of rake
15 degrees of rake angle design, make the car more aggressive in the entrance, so that the KIT-D4AWD drift performance is more real.
Double arm large steering angle design
The steering system uses a double arm type large steering angle design; the action of the reverse steering of the KIT-D4AWD is increased and the performance of the vehicle at high speed is optimized.
Internal gear ratio
KIT-D4AWD internal tooth ratio is 1.47..
Double belt drive design
KIT-D4AWD drive system used the design of double belt, increasing vehicle in high speed stability, especially in the high-speed turn, the speed limit should not be slowed down rapidly, so that KIT-D4AWD maintained a certain corner entry speed and fluency.
Large angle universal joint dog bone KIT-D4AWD the whole car is equipped with a 65 degree - large angle universal joint dog bone.
New wheel design
The design of the new bell is equipped with high performance tires enhance the appearance of the KIT-D4AWD drift.

• RWD/4WD professional RC CARS

RWD/4WD professional RC CARSHOBBYT