PRE-APPLICATION INSTRUCTIONS If possible bring your vehicle into a building. If it's cold outside then a warm building will help adhesion of the material to the surface of the window. Keeping material out of direct sunlight during hot temperatures will also help you during the installation process. Clean surface thoroughly with soap and water or appropriate window cleaner. If you use any heavy duty cleaners to remove adhesive or tar then make sure you remove all residue left behind from the cleaners. Denatured alcohol is a good cleaner for removing any last bits of this type of residue. APPLICATION INSTRUCTIONS 1. Using masking tape, pre-position your new Creative Tint's graphic into desired position. 2. Secure the image by taping one edge of your image and removing the positioning tape. 3. Carefully peel off backing from the back of your new graphic. 4. Apply the graphic from the edge you just taped and work to the opposite side, smoothing out the image as you go to prevent bubbles and wrinkles. 5. Trim the excess away from the edges of the window. 6. Burnish the edges of your graphic to ensure there are no loose edges.

• 6 mil perforated window film
• 50/50 Perforation pattern holes for optimal two-way viewing
• Available in four sizes
• Custom design by Creative Tints, only available here
• Made in the U.S.A.

6 mil perforated window filmPacific Soul