You are purchasing one set of ski racks(ski and poles not cinluded).
1. Measure the thickness of your two boards , and mark the two points. The best placement is the point where the straight sides start to flare out towards the top of the board.
2. Fasten the bottom of the column with three screws on the marked point.
3. Roll the column on the bottom easily.
4. Slid the boards down, and they will stay on your wall vertically.

• 1. Tough material - Our rack is made of stainless steel column. Never rust. Extremely resistant to rot and decay. Hold over 100 lbs of equipment.
• 2.Hold poles. - This rack is suitable for ski and poles. One pair of ski needs two clinches. （one on each side）
• 3.Thick Foam Protector- The column is covered with 5MM thick foam, which protects your board edges from getting damaged while resting in the rack.
• 4.Vertical design －designed to hold your ski vertically
• 5. Easy to install： Instruction included.

1. Tough material - Our rack is made of stainless steel column. Never rust. Extremely resistant to rot and decay. Hold over 100 lbs of equipment.Yi Ya Su