* Notes: Please Make Sure All Taillights Are Installed Properly, Sockets Are Tightly Fastened And All O-Rings Or Rubber Gaskets Are In Great Condition. Broken Or Loose O-Rings Or Rubber Gaskets On Your Factory Sockets Can Cause Moisture In Your Lights ( It Can Damage Your Light Bulb ). If You Happen To Have Moisture Buildup In Your Lights, Please Try The Following Solution. Simply Remove The Lights From The Vehicle And Set Out In The Sun Or In A Dry Area For At Least Few Hours. Wait Until The Moisture Has Fully Evaporated, And Reseal Around The Seams With A Clear Silicone Sealant On The Assembly And Replace Any Worn Down O-Rings Or Rubber Gaskets. This Should Alleviate The Condensation Issue. ** Installation : Follow These Steps For An Easy Tail Light Replacement Process. Find A Path To The Back Of The Tail Light Housing. Every Car Is Different And Uses Either Screws To Hold The Tail Light In From The Outside, Or Has A Panel Inside The Car That Covers The Back Of The Tail Light. Remove Any Bolts Or Fasteners In Your Way. Once You See The Back Of The Tail Light, Unplug The Harness And Remove The Hold Down Screws. With Everything Out In The Open, You Are Free To Swap The Bad Bulb For A Good One. Or, Bolt In A New Set Of Led Tail Lights.

• Application: 2000-2006 GMC Yukon / Yukon XL Models, 2001-2006 GMC Yukon Denali / Yukon XL 1500 Denali Models, 2000-2006 Chevy Suburban Models, 2000-2006 Chevy Tahoe Models ( Will Not Fit Barn Door Models )
• Comes With A Set ( Driver & Passenger Side )
• Color: Red Smoke
• Direct Bolt-On Replacement

Application: 2000-2006 GMC Yukon / Yukon XL Models, 2001-2006 GMC Yukon Denali / Yukon XL 1500 Denali Models, 2000-2006 Chevy Suburban Models, 2000-2006 Chevy Tahoe Models ( Will Not Fit Barn Door Models )WTG