The best combination and price, it includes everything you need to get started interacting with YOUR Raspberry Pi 3B,2B.
The Smraza Starter Kit offers a wider variety of components Such as a Black case, 5V/2.5A power supply,GPIO Breakout board,HDMI cable,Jumper Wires,Breadboard and LEDs etc to start your learning and creativity.

Package Included:
1) Black case x1
2) Aluminium Heat Sinks x2
3) 16G SD Card x1
4) Card Reader x1
5) 5V/2.5APower Supply x1
6) USB Cable with on/off Switch x1
7) HDMI Cable x1
8) 400 tie-points Breadboard x1
9) 40 pin GPIO Cable x1
10) 40 pin GPIO Extension Board x1
11) Male to Female Jumper Wires x10
12) 35*Jumper Wire x1
13) 12mm Buttons(large) x5
14) Red LEDs x5
15) Yellow LED x5
16) Resistor (330R) x20
17) Resistor (10K) x20


Smraza is a professional manufacturer on making all electronics components based on Arduino and Raspberry Pi. If you have any technical questions, please contact us by email to get support.

• The case is a two-piece injection-molded ABS enclosure that snaps together around your Raspberry Pi 3B and your Rasberry Pi 2B.Nice appearance, good touch feeling Slim, form-fitted and lightweight.
• The 16GB Micro SD card with high speed SDHC class 10 UHS-1, it adapts to operating system for Raspberry Pi 3B,2B. If you need it, please contact us by Email for detailed documentation.
• The HDMI Cable(Meets HDMI 1.4 specification) with high speed,the HDMI cable allow you to share an Internet connection and it also supports 3D.
• 5V/2.5A Power Supply adapter,Support short circuit protection and overload protection.Micro USB Cable with ON / OFF switch, no need to pull the cable to restart your Pi, just press the button to turn your Pi on and off (Not support data transfer).
• The kit also includes GPIO to Breadboard Interface Board,Ribbon Cable, 830 tie-points breadboard, Jumper Wires and RGB LED, 5 x LEDs (Blue/Red/Yellow/Green), 25 x Resistors, 5 x Push Button Switches. Learn to interact with the GPIO through Python and Scratch(The Raspberry Pi board is not included)

The case is a two-piece injection-molded ABS enclosure that snaps together around your Raspberry Pi 3B and your Rasberry Pi 2B.Nice appearance, good touch feeling Slim, form-fitted and lightweight.Smraza