The best combination and price, it includes everything you need to get started interacting with YOUR Raspberry Pi 3B,2B.
The Smraza Starter Kit offers a wider variety of components Such as a 9 layers case,5V/2.5A power supply,HDMI cable,Jumper Wires,Breadboard and LEDs etc,and with the GPIO port to jump start your learning and creativity.

Attention:
1.This kit is Not include the Raspberry Pi Board.
2.The 9 layers case contains different components(with different colors), it need to follow the detailed guide. Before you assemble it, we hope that you can read our case installation guide and refer it.
2. Then you need to peel paper off the plastic pieces.


Package Included:
1) 9 Layers case x1
2) Aluminium Heat Sinks x3
3) Fan x1
4) 16G SD Card x1
5) Card Reader x1
6) 5V/2.5APower Supply x1
7) USB Cable with on/off Switch x1
8) HDMI Cable x1
9) 400 tie-points Breadboard x1
10) 40 pin GPIO Cable x1
11) 40 pin GPIO Extension Board x1
12) Male to Female Jumper Wires x10
13) 35*Jumper Wire x1
14) 12mm Buttons(large) x5
15) Red LEDs x10
16) Yellow LED x10
17) Resistor (330R) x20
18) Resistor (10K) x20


About Smraza:
We are a leading manufacturer of electronic components for Arduino and Raspberry Pi. We have a professional engineering team dedicated to providing tutorials and support to help you get started.
If you have any technical questions, please feel free to contact our support staff via email.

• 9 layers protection case with instructions: This case is made of 9 individual layers with a powerful fan and 3pcs Aluminium Heat Sinks. You can use 4 nylon bolts assembly without tools.(The Raspberry Pi board is Not included)
• The 16GB Micro SD card with high speed SDHC class 10 UHS-1, it adapts to operating system for Raspberry Pi 3B and RPi 2B. If you need it, please contact us by Email for detailed documentation.
• The HDMI Cable(Meets HDMI 1.4 specification) with high speed, the HDMI cable allow you to share an Internet connection and it also supports 3D.
• 5V/2.5A Power Supply adapter,Support short circuit protection and overload protection. Micro USB Cable with ON / OFF switch, No need to pull the cable to restart your Pi, just press the button to turn your Pi on and off (Not support data transfer).
• The kit also includes GPIO to Breadboard Interface Board,Ribbon Cable, 830 tie-points breadboard, Jumper Wires and RGB LED, 5 x LEDs (Blue/Red/Yellow/Green), 25 x Resistors, 5 x Push Button Switches. Learn to interact with the GPIO through Python and Scratch.

9 layers protection case with instructions: This case is made of 9 individual layers with a powerful fan and 3pcs Aluminium Heat Sinks. You can use 4 nylon bolts assembly without tools.(The Raspberry Pi board is Not included)Smraza