The best combination and price, it includes everything you need to get started interacting with YOUR Raspberry Pi 3,2.
The Smraza Starter Kit offers a wider variety of components Such as a 5V/2.5A power supply,HDMI cable,Jumper Wires,Breadboard and LEDs etc, and with the GPIO port to jumper start your learning and creativity.


Note:
1.The 9 layers case contains different components(with different colors), it need to follow the detailed guide. Before you install this case, we hope that you can read our case installation guide and refer it.
2.Then you need to peel paper off the plastic pieces before you assemble it.


Package Included:
1) 8 Layers Case x1
2) Aluminium Heat Sinks x3
3) 16G SD Card x1
4) Card Reader x1
5) 5V/2.5APower Supply x1
6) USB Cable with on/off Switch x1
7) HDMI Cable x1
8) 40 pin GPIO Extension Board x1
9) 40 pin GPIO Cable x1
10) Male to Female Jumper Wires x10
11) 35*Jumper Wire x1
12) RGB LED x1
13) 12mm Buttons(large) x5
14) Red LEDs x5
15) Green LEDs x5
16) Yellow LED x5
17) Blue LED x5
18) Resistor (220R) x15
19) Resistor (10K) x10
20) 830 tie-points Breadboard x1


Smraza is a professional manufacturer on making all electronics components based on Arduino and Raspberry Pi.If you have any technical questions, please contact us by email to get support.

• The 8 layers case is compatible with Raspberry Pi 3 B 2 model B. It is made of 8 individual layers and 3pcs aluminum heat sinks(With Color Quick-Start Guide), you can assemble it easily by 4 nylon bolts without tools.
• The 16GB Micro SD card with high speed SDHC class 10 UHS-1 , it adapts to operating system for Raspberry Pi 3,2. If you need it, please contact us by Email for detailed documentation.
• The HDMI Cable(Meets HDMI 1.4 specification) with high speed,the HDMI cable allow you to share an Internet connection and it also supports 3D.
• 5V/2.5A Power Supply adapter,Support short circuit protection and overload protection.Micro USB Cable with ON / OFF switch, no need to pull the cable to restart your PI, just press the button to turn your Pi on and off (Not support data transfer).
• The kit also includes GPIO to Breadboard Interface Board,Ribbon Cable, 830 tie-points breadboard, Jumper Wires and RGB LED, 5 x LEDs (Blue/Red/Yellow/Green), 25 x Resistors, 5 x Push Button Switches. Learn to interact with the GPIO through Python and Scratch(The Raspberry Pi board is not included.)

The 8 layers case is compatible with Raspberry Pi 3 B 2 model B. It is made of 8 individual layers and 3pcs aluminum heat sinks(With Color Quick-Start Guide), you can assemble it easily by 4 nylon bolts without tools.Smraza