Programming Instructions for SEIP 433 RC-AM remote controls Method 1 (use this procedure only if you have an existing working midi keyfob transmitter with four buttons and a Seip model A45, A60, C75 or C100 operator) 1. Briefly depress the two lower buttons on the original handset simultaneously, a beeping sound should now be heard from the motor unit to indicate that the receiver has entered into 'code learning mode' You have 10 seconds to perform the next step. 2. Take the new keyfob and press the button that you wish to use to operate your door and hold briefly 3. Your new handset should now operate your garage door. Note: If you have more than one Seip motor in your garage it will be necessary to switch off the power to each motor in turn to avoid both receivers entering the 'code learning mode' together, or use method 2 Method 2 If you are unable to use method 1 above because you don't have an original working keyfob with four buttons or you have a Seip model M50 operator it will be necessary to release the fixing screw at the rear centre of the motor casing and open the hinged cover and proceed as follows: 1. Locate the programming button on the decoder PCB inside the motor casing, (see photo right) and press it briefly (a yellow LED will flash on the decoder PCB or a bleeping sound will be heard), you have 10 seconds to perform the next step. 2. Take the new handset and press the button that you wish to use to operate your door for one second. 3. Your new handset should now operate your garage door. (Note: the Seip receiver modules type WAM1K & WAK1K have a small black programming button on the casing) If you want to increase the remote control reception range up to 150-200 meters, then you can connect this aerial: https://www.amazon.com/dp/B01MSRPVD2

• High quality SEIP compatible remote control replacement!
• This remote control replacement fully compatible with following SEIP remote models: SEIP RC-AM SEIP RC-AM Mini
• Latest technology 433.92Mhz rolling code remote! / Distance up to 100 meters! Battery and keychain included!
• Compatible with the following SEIP garage door operator models: A45, A60, C75, C100, M50 / Compatible with SEIP receivers like: WAM1K, WAK1K

High quality SEIP compatible remote control replacement!SEIP compatible remote